NEW INJECTORS ARE EXPENSIVE
Your existing injectors can perform as NEW.
We rebuild injectors quickly and efficiently using our State-of-the-art Computerized Flow Bench
Dirty injectors cause an imbalance in your engine resulting in multiple problems.
We eliminate the varnishes, lacquers, hard ash, carbon and tar deposits built up over time, inside injectors!
Increasing Performance and Restoring Mileage!
The major reason for the replacement of injectors is that deposits build up inside them and reduce their performance. A layer of just 5 microns on the internal surfaces can restrict fuel flow by up to 25%. (Even a 10% restriction in flow rate could cause a noticeable deterioration in vehicle driveability).
"Injectors to Go!
We test, using three-phase test procedures, checking for leaks, spray pattern and flow rates, under pressure, pulsing through computer simulated engine conditions, from 600 to 5000 RPM, and document results.
We disassemble injectors and clean using strong alkaline aqueous detergents and the most powerful adjustable frequency Ultra-Sonics in the industry!
We re-test for leaks, spary pattern and flow rates, comparing results to previous tests, and document improvements.
We test for integrity, stress under electrical load, and check for possible faults in coil windings.
We reassemble, installing new parts, O-rings, filter basket and pintle caps. We then run the final three-phase test procedure, checking static and dynamic flow rates on injectors. Finish documentation and return data with completely finished injectors to YOU!
Ask for Your set of "Injectors to Go!" Today!
For classic carburetors make sure that you check out our Carburetor ID Guide
San Diego Carburetor & Fuel Injection, Inc. © Copyright 1997 - 2008 San Diego Carburetor & Fuel Injection, Inc. All Rights Reserved.
E Mail Us
6622 University Avenue, San Diego, California, 92115
Phone: (619) 265-2400
Open Monday thru Thrusday, 9:00am till 5:00pm.
Friday till 6:00pm.